Turn ON FR-X

===== Turn in-house FR-X ON =====

----

==== Technical Room E0044 ====

Turn the tap on the main water inlet to the ON position.

{{:crystallography:collection:frx:red_valve.jpg?400|}}

Switch ON the water chiller (HASKRIS) using the main switch only.
Wait until the temperature is stabilized at 17°C.

{{:crystallography:collection:frx:haskins.jpg?200|}}
{{:crystallography:collection:frx:haskins_closeup.jpg?400|}}

Switch ON the nitrogen compressor at the back, then start the nitrogen flow with the touch panel.
After a 3 min idle wait, the pump should stabilize in 30 min.
Wait for 1 h.

{{:crystallography:collection:frx:n2.jpg?150|}}
{{:crystallography:collection:frx:n2_closeup.jpg?400|}} 

----

==== FR-X ====

Switch ON the two fans of AFC-11.

{{:crystallography:collection:frx:acf11_back.jpg?400|}}

Switch ON AFC-11 Goniometer controller.

{{:crystallography:collection:frx:afc11_closeup.jpg?600|}}

Switch ON the vacuum pump below the Cobra Controller.

{{:crystallography:collection:frx:pump1.jpg?250|}}
{{:crystallography:collection:frx:pump1_closeup.jpg?250|}}

Switch ON the vacuum pump below the BioSAXS.

{{:crystallography:collection:frx:pump2.jpg?250|}}
{{:crystallography:collection:frx:pump2_closeup.jpg?350|}}

Switch ON the transformer.

{{:crystallography:collection:frx:main_power_supply.jpg?600|}}

Reset and then switch ON the generator at the back.

{{:crystallography:collection:frx:frx_back.jpg?400|}}

POWER ON on the front main panel.
Press both DOOR LOCK buttons.

{{:crystallography:collection:frx:frx_front.jpg?600|}}

Start the Vacuum on the XG Control panel. 
Wait until vacuum is below 1.10E-4 (about 1h30).

{{:crystallography:collection:frx:xg.png?600|}}

Turn X-Rays ON on the XG Control panel.
Wait 1-2h if it was down for a few hours (heating will generate gaz that may disrupt the vacuum if the level is not low enough). Wait overnight if it was down for a few weeks.

Start the AGING procedure.
Short aging lasts 31 min, long aging lasts 6h. 
Wait 1h30 for the beam to stabilize before data collection.

----

==== Cryostream ====

Switch ON the helium compressor.

{{:crystallography:collection:frx:helium.jpg?300|}}
{{:crystallography:collection:frx:helium_back.jpg?250|}}

Switch ON on the back of the device.

{{:crystallography:collection:frx:cobra_back.jpg?600|}}

Cycle Start/Start
For the first hour the temperature won't really decrease much.
Final temperature should be around 100 K.

{{:crystallography:collection:frx:cobra_front.jpg?600|}}

----

==== Detector ====

Switch ON the EIGER water chiller.

{{:crystallography:collection:frx:eiger_chiller.jpg?400|}}

Switch ON the power supply for the EIGER.

{{:crystallography:collection:frx:eiger_power_supply.jpg?600|}}

Switch ON the framegrabber.

{{:crystallography:collection:frx:framegrabber.jpg?600|}}